Skip to content

The work

Gallery

Commissions, restorations and watch work, illustrated with generated imagery and short notes on how each job can be approached.

Pearls, a brooch, a ring and a watch in a sorting tray

Grouped by the kind of work rather than by date, because what people are usually looking for is an example of their own problem solved.

Group 01

Commissions

Designs built around the stones, the way the piece will be worn, and what the wearer wants to keep.

  • An emerald-cut diamond solitaire in platinum on a warm grey surface

    Engagement ring — emerald-cut solitaire, tapered platinum band

    A low setting can help the ring clear a cuff.

  • A three-stone gold ring beside an antique brooch mounting

    Remodelled heirloom — three stones from a brooch, reset as a trilogy ring

    The original brooch can be photographed and recorded before the stones are reset.

  • A shaped wedding band sitting flush against a solitaire ring

    Wedding band — shaped to sit flush against an existing engagement ring

    The band follows the curve of the solitaire so the two sit together.

  • An oval gold signet ring with a recessed botanical engraving

    Signet ring — hand-engraved motif on an oval gold face

    A hand-cut design gives the gold face depth and catches the light.

Group 02

Restoration

Ways to return older pieces to use while preserving as much of the original as possible.

  • A Victorian-style gold brooch with red stones and visible patina

    Victorian gold brooch — pin remade, two stones reset, patina left alone

    A pin can be remade and loose stones reset while preserving the surface patina.

  • A close-up of the round diamonds and claws on a platinum half-eternity ring

    Diamond half-eternity — four claws re-tipped, all stones checked and tightened

    A loose stone is a reason to check the claws on neighbouring stones, too.

  • A strand of cream pearls with knots between each pearl

    Pearl strand — restrung on silk, knotted between each pearl, clasp replaced

    Individual knots help hold the remaining pearls in place if the silk breaks.

  • Interlocking gold curb-chain links on grey slate

    Gold curb chain — worn link replaced, full length checked for the next weak point

    Replacing one worn link is a good moment to check the entire chain for wear.

Group 03

Watch work

Movement servicing, case and bracelet work, and checks that help establish how a watch is performing.

  • A steel chronograph on a timing microphone cradle

    Automatic chronograph — full service, timing restored across five positions

    A watchmaker can record timing across several positions after a service.

  • A 1960s-style gold dress watch with a domed crystal

    Dress watch, 1960s — crystal replaced, case left unpolished at the owner's request

    Replacing a crystal can improve legibility while preserving the case’s original lines.

  • A steel diver’s watch inside a pressure-test chamber

    Diver's watch — pressure testing after seal replacement

    Pressure testing checks how the seals perform after replacement.

  • An open steel watch bracelet beside spare links and pins

    Steel bracelet — stretch assessed, pins and links replaced, clasp retensioned

    Worn pins can contribute to play between the bracelet links.

These illustrations show examples of the kinds of work ECBH offers. Ask us about photographs of completed work.

Something like one of these?

Send a photograph of your own piece and tell us what you would like to happen to it. The first answer costs nothing.